Kool Dry Dryer Maintenance and Repair

Maintenance Instructions

 

Your Kool Dry Dryer or Kool Raptor Dryer is equipped with two filter systems.

Your Kool Dry Pup is equipped with only one inlet filter.
1. CLEANING THE OUTSIDE INLET FILTER:  This filter is on the outside front of the unit.  It can be removed by pulling it out with your fingers.   After removing it from the unit, clean with warm, soapy water, rinse and allow the filter to dry completely before reinserting in the unit.  Maintaining this filter will extend the time needed to clean the internal filter.
2.  CLEANING THE INTERNAL FILTER:  UNPLUG THE DRYER FROM THE ELECTRICAL OUTLET.  This filter is located inside the box on the rear of the motor.  Remove the Phillips-head screws from all four sides of the front panel, and slide the motor module from the case.  Remove the filter (dome shape) and clean with warm, soapy water, rinse and allow the filter to dry completely before reinserting into the unit.  Reinsert the filter.  Make sure the wire nuts that hold the respective wires together have not come loose.  Slide the motor module back into the case.  Re-install the Phillips-head screws on all sides of the front panel.  Maintaining this filter will help preserve the life of the motor.  For motor brush replacements – please contact us.

Dryer Repair 

Warranty Repair

For warranty repair (within 1 year of purchase) your dryer must be sent to the Manufacturer: Chris Christensen Systems325 Industrial Park Drive, Fairfield, TX 75840 USA

Out of Warranty Repair

Please Contact Us.